A quick look at a Simpson 260.
Wednesday, June 3, 2026 at 05:06:14
I had a request in regards to a Simpson 260 multimeter. I was asked if I knew what the handle bolt sizes are - I do not, but I decided to take a quick look to determine if there was anything of use easily visible. I have a series 8 available, so I said I’d take a look.
The first thing of interest is the handle itself. The handle is held on by two large hex bolts with a thin head. These bolts pass through the handle. Inside the handle itself is a piece of metal. This metal pivots with the handle, but doesn’t necessarily appear to be part of the handle.
The bolt then passes on through the case.
Unfortunately, I can’t get this apart to measure the end of that, I suspect these have to come out before the meter assembly pulls from the case back.
That’s all - this was just a check of some parts on the unit. Stay tuned, more good junk on the way!